電気学会論文誌A(基礎・材料・共通部門誌)
Online ISSN : 1347-5533
Print ISSN : 0385-4205
ISSN-L : 0385-4205
132 巻, 9 号
選択された号の論文の24件中1~24を表示しています
特集:テラヘルツ波
特集論文
論文
  • 冨田 一
    2012 年132 巻9 号 p. 753-759
    発行日: 2012/09/01
    公開日: 2012/09/01
    ジャーナル フリー
    In this study, I experimentally clarified the nature of the characteristics of the electrostatic discharge (ESD) that occurs when a charged object moves toward a stationary grounded object. The spark lengths, discharge currents, and induced voltages in a magnetic probe were measured when a charged metallic spherical electrode connected to a 422 pF capacitor approached a stationary grounded object, which was the current target, for different moving speeds of the charged metallic spherical electrode in the range of 1-100 mm/s. The charge voltages of the capacitor were +6.5 kV and +10 kV. According to the result, the average gap length shortened with the moving speed of the spherical electrode. The average peak values of the discharge current and the induced voltage were likely to increase with the moving speed of the spherical electrode. The average rise times of the discharge current and the induced voltage were likely to reduce with the moving speed of the spherical electrode. The relation between the spark length and the discharge current due to ESD can be explained qualitatively by using an equation derived from the spark resistance formula proposed by Rompe and Weizel.
  • 荒井 友之, 細淵 柾志, 布施 則一, 武田 京三郎, 大木 義路
    2012 年132 巻9 号 p. 760-766
    発行日: 2012/09/01
    公開日: 2012/09/01
    ジャーナル フリー
    Optical absorption spectra and photoluminescence spectra were obtained for eight kinds of polyolefin sheet samples using photons in a range from visible to vacuum ultraviolet. Almost all samples were found to exhibit an absorption peak at around 6.5 eV and a luminescence band at around 4.3 eV. The luminescence was found to be induced by the absorption. Furthermore, it was found that successive absorption of ultraviolet photons weakened the luminescence intensity. It is assumed from these results that α, β-unsaturated carbonyls are luminous and that the carbonyls are decomposed through the Norrish type II reaction by absorbing ultraviolet photons. Quantum chemical calculations were carried out using polyethylene models with and without an unsaturated carbonyl to verify the above-mentioned assumption. As a result, the model with an unsaturated carbonyl was found to have localized electronic states in the forbidden band. One of the differential energies between the states is close to the photon energy, by which the luminescence is induced. The bond length of a double bond, which is next to the carbonyl, was found to be longer at the excited singlet state than at the ground state. These results obtained by computation support the above-mentioned assumption of the luminescence center and its decomposition.
  • 林 竜一, 大保 勇人, 竹内 希, 安岡 康一
    2012 年132 巻9 号 p. 767-772
    発行日: 2012/09/01
    公開日: 2012/09/01
    ジャーナル フリー
    Complete decomposition of perfluorooctanoic acid (PFOA) at a concentration of 41.4mg/L and perfluorooctane sulfonate (PFOS) at a concentration of 60mg/L in water was successfully demonstrated by DC plasma within oxygen bubbles. PFOA and PFOS were decomposed completely after 3-hour operation and 8-hour operation, respectively. The decomposition efficiency was evaluated by measuring the amounts of fluorine ions which were detached from PFOA or PFOS in the solution. From the measurement of LC/MS, the main by-products generated during the plasma treatment turned out to be perfluorocarboxylic acids. For the practical application, 2-parallel operation of DC plasma was also demonstrated as a basic technology for a large capacity reactor. The decomposition efficiency of 2-parallel operation was at the same level as that of single operation.
  • 小迫 雅裕, 中津 秀幸, 戸田 弘明, 山田 修平, 吉永 耕二, 匹田 政幸, 平田 大裕, 宮本 剛寿, 武井 雅文
    2012 年132 巻9 号 p. 773-779
    発行日: 2012/09/01
    公開日: 2012/09/01
    ジャーナル フリー
    Multi-walled carbon nano-tubes (CNT)/epoxy nano-composites were fabricated and coated onto epoxy insulating substrates in order to uniformize the surface conductivity. The effects of polymer functionalization of CNT were investigated on the dispersion of CNT in an epoxy matrix and the electrical surface conductivity. It was elucidated that grafting polymer molecules onto the CNT surface improve the dispersion of CNT in an epoxy matrix compared to those containing CNT without functionalization. The surface conductivity of nano-composites decreases thanks to uniform dispersion of CNT.
  • 三浦 雅和, 福間 眞澄, 岸田 悟
    2012 年132 巻9 号 p. 780-789
    発行日: 2012/09/01
    公開日: 2012/09/01
    ジャーナル フリー
    Polyvinyl chloride (PVC) is the most popular insulating material for electrical wiring instruments. The exothermic reaction at over 150°C may cause deterioration of insulating properties in the PVC. Therefore, it is important to clarify heat degradation in the PVC, not only to investigate ignition of electrical wiring instruments but also to use electric products safely. It is known that ultraviolet ray (UV) irradiation causes PVC chemical deterioration and the conductivity increases.
    Generally it has been considered that the electrical breakdown property, electrical conduction and insulating performance are affected by the space charge accumulation in the insulation material. A high temperature pulsed electroacoustic (PEA) system up to 250°C has been developed, and the PEA system can measure the space charge distribution and conduction current in the high temperature, simultaneously. In this paper, the space charge distribution and conduction current have been measured up to electrical breakdown in the non-UV-irradiated sample (normal PVC), 353nm and 253nm UV-irradiated PVC sample in the range from room temperature to 200°C under DC electric field. In the short wavelength UV irradiated (253nm-300hour) PVC sample, the deterioration of breakdown strength at 90 to 150°C, and the negative packet-like charges are observed at 60 to 100°C, the positive charge accumulated in front of both the anode and the cathode over 90°C, and electric field is higher near the cathode side because the amount of positive charge of cathode side is larger.
  • 藤井 治久, 奥村 哲平, 高橋 真人
    2012 年132 巻9 号 p. 790-796
    発行日: 2012/09/01
    公開日: 2012/09/01
    ジャーナル フリー
    Many kinds of insulating materials are used outside a spacecraft. Those are FEP films, polyimide films and so on, and are used as thermal control materials. These materials are exposed to charged particles environment around a spacecraft. So these materials charge up due to the charged particles, especially electrons. It is pointed out that charge-up on these materials is likely to cause discharges on the surfaces. From this viewpoint, we have investigated the charging potential characteristics of 127 μm thick FEP film, typical thermal control material, by irradiating electrons with various energies below 20 keV. In the dependence of the charging potential on the electron energy, we found that the electron energy at which no charge-up occurs is about 2.7 keV. It is thought to be the energy at which secondary electron emission yield becomes one. This indicates that electron irradiation to the FEP film with the energy lower than 2.7 keV induces positive charging. From the charge decay characteristics after electron irradiation the volume resistivity of the film was also obtained as a function of electric fields in the bulk of the FEP film.
  • 栗原 隆史, 倉石 隆志, 高橋 俊裕, 高橋 紹大, 鈴木 寛, 岡本 達希
    2012 年132 巻9 号 p. 797-804
    発行日: 2012/09/01
    公開日: 2012/09/01
    ジャーナル フリー
    In order to propose a method for producing water trees that measure a few millimeters in length in 20kV class to 60kV class XLPE cables, we discussed defect types and thermal conditions. First, surface roughness, needle protrusions, and line cracks were formed on the XLPE insulation surface of 6.6kV cables, and it was found that the water tree grew to a few millimeters in length from the needle protrusions and the line cracks. Second, water trees were generated in XLPE sheet and cable samples at room temperature and under a heat cycle and continuous elevated temperature conditions. Here, the longest water trees grew at room temperature. From these results, we selected needle protrusions and line cracks as defects and set room temperature as an artificial water tree degradation method. This method was applied with needle protrusions to a 22kV class XLPE cable, and we found that water tree length reached a few millimeters and AC breakdown voltage decreased to approximately 35% of the initial value.
研究開発レター
 
部門記事
 
feedback
Top