粉体および粉末冶金
Online ISSN : 1880-9014
Print ISSN : 0532-8799
ISSN-L : 0532-8799
34 巻, 2 号
選択された号の論文の7件中1~7を表示しています
  • 沖本 邦郎
    1987 年 34 巻 2 号 p. 51-59
    発行日: 1987/02/25
    公開日: 2009/05/22
    ジャーナル フリー
  • 原田 幸明, 武田 徹, 皆川 和己
    1987 年 34 巻 2 号 p. 60-65
    発行日: 1987/02/25
    公開日: 2009/05/22
    ジャーナル フリー
    Dilatometric examination was used to investigate the sintering of the higher-pressure water atomized Ni-20%Cr super fines. It was confirmed that sinterability of the super fines was superior to alloy powders atomized with the ordinary water pressures. Sintering in hydrogen atmosphere improved the sinterability of the Ni-20%Cr super fines, which was due to the fact that the main sintering mechanism of Ni-20%Cr super fines in hydrogen atmosphere was volume diffusion while grainboundary diffusion was the main mechanism in both argon and vacuum atmosphere.
  • 本間 克彦, 立野 常男, 岡田 広
    1987 年 34 巻 2 号 p. 66-72
    発行日: 1987/02/25
    公開日: 2009/12/04
    ジャーナル フリー
    α-SiC and β-SiC starting powders mixed with 1 wt% B and 1 wt% C as densification aids, were pressed and normally sintered at 2000-2200°C. These sintered compacts and commercial sintered compacts (Kyo-sera, SC201) were HIP'ed without capsule using in 100 MPa Ar gas and N2 gas at 1700°C.
    Weight change, density and flexural strength were investigated, and the results obtained were summarized as follows:
    (1)The amount of weight gain during N2-HIP treatment which was remarkably large in case of low temperature sintered compacts (about 15%), was caused by the reaction between high pressure N2 gas and SiC.
    (2)The density of all specimens increased by HIP treatments, and the density of N2-HIP'ed compacts was increased with the weight gain.
    (3) The flexural strength of sintered a-SiC and commercial SiC compacts increased by HIP treatments, and the higher strength was obtained in case of N2-HIP treatment. It was considered that the flaw size in SiC compacts was apparently decreased by the rod like Si3N4 crystal which was formed y the reaction between N2 gas and SiC.
  • 本間 克彦, 立野 常男, 岡田 広
    1987 年 34 巻 2 号 p. 73-77
    発行日: 1987/02/25
    公開日: 2010/07/12
    ジャーナル フリー
    Si3N4 powders mixed with 6wt%Y2O3-2-6wt%Al2O3 and 6wt%Y2O3-1.5wt%MgO as sintering aids, were pressed and normally sintered at 1600°C. The sintered compacts were HIP'ed without capsule using in 100 MPa nitrogen gas at 1700°C. Density, weight change, a to β phase transformation and flexural strength were studied, and the results obtained were summarized as follows:
    (1) The amount of weight loss during sintering was relatively small in case of Y2O3-Al2O3 series, so that the sinterability was better than in Y2O3-MgO series.
    (2) In case of both the series, the amount of a to β transformation in sintered compacts was decreased compared with the compacts which contained 6 wt%Y2O3 only, and the tendency in Y2O3-Al2O3 series was more remarkable than in Y2O3-M90 series.
    (3) The mean strength of Y2O3-Al2O3 series was improved from 340 to 700 MPa by HIP treatment. It was found that the improvement of strength depended on not only density, but also a toβ transformation and fibrous structure formation in Si3N4 during HIP treatment.
  • 吉村 昌弘, 鈴木 和雄, 宗宮 重行
    1987 年 34 巻 2 号 p. 78-84
    発行日: 1987/02/25
    公開日: 2009/05/22
    ジャーナル フリー
    Titanium and zirconium powders did not yield nitrides effectively by the treatment in pressurized ammonia of 1 MPa and above, at 700°C for 3 h. The addition of NH4Cl was effective for the nitridation of Ti and Zr. Reactions of titanium powder (99.1 % up) mixed with 10 wt% (9.2 mol%) ammonium chloride have been studied at 300-700°C under 0.1 or 1 MPa NH3 (initial pressure) for 3 h. Ti and NH4CI did not react at 300°C, but formed TiH1.924 at 400°C, and then TiH1.924 changed into TiN above 500°C. When the sample of Ti-10 wt% NH4Cl was heated at 300-600°C under 0.4 MPa Ar gas for 3 h, TiH1.924 was produced at 400°C and above, but TiN was not produced.
    When the sample of Zr-10 mol% (6 wt%) NH4Cl was heated under 0.1 or 1 MPa NH3, ZrN was formed above 600°C through the formation of ZrH and ZrH2 above 400°C. A small amount of β-ZrNCI was also produced at 700°C under the same conditions.
  • 山本 修之
    1987 年 34 巻 2 号 p. 85-90
    発行日: 1987/02/25
    公開日: 2009/05/22
    ジャーナル フリー
    Relations between PTC effect and reactions observed in DTA were investigated in the temperature range of 25 to 1400°C on the specimens prepared by adding SiO2 or Si3N4 to Y-doped BaTiO3. Two kinds of eutectic reactions were observed in DTA, i.e. reaction A at 1184-1238°C, and B at 1290-1327°C. Resistivity was measured on the specimens quenched before and after these reactions took place. Compared to the specimen quenched after reaction A, remarkable reduction in PTC effect was observed in the specimen quenched before reaction A. Quenching from much higher temperature, i.e. above reaction B temperature, however, gave a larger PTC effect. Microstructures of boundary phases suggested that Ti-rich phase (Ba6Ti17O40) played an important role on the appearance of PTC effect.
  • 玉利 信幸, 近藤 功, 木下 実
    1987 年 34 巻 2 号 p. 91-94
    発行日: 1987/02/25
    公開日: 2009/05/22
    ジャーナル フリー
    Addition effects of some fluorides, NaF, MgF2, CaF2 and AIF3, on the densification and the mechanical properties (Bending strength, fracture toughness) of hydroxyapatite were investigated. Sintering treatments were performed by hot-pressing under 10 min-20 MPa. An addition amount of each fluoride was fixed at 2.5 wt%. Of above fluorides added, calcium fluoride brought on extremely good results for the sintering of hydroxyapatite. The sintered compacts having relative densities more than 98% were obtained from 900°C in the case of adding calcium fluoride. On the other hand, the hydroxyapatite single compacts were fully densified above 1200°C. Moreover, the hydroxyapatite compacts containing calcium fluoride had a little higher bending strengths and fracture toughnesses than the hydroxyapatite single compacts because of the difference of their fine structures or grain sizes. Addition of other fluorides, on the contrary, obstructed the densification of hydroxyapatite.
feedback
Top