巻号一覧
前身誌
29 巻, 9 号
選択された号の論文の8件中1～8を表示しています
- |<
- <
- 1
- >
- >|
-
大島 敏男1992 年 29 巻 9 号 p. 661
発行日: 1992/09/10
公開日: 2010/04/30
ジャーナル フリーPDF形式でダウンロード (1640K) -
水野 光国, 神保 元二1992 年 29 巻 9 号 p. 662-668
発行日: 1992/09/10
公開日: 2010/04/30
ジャーナル フリーIn the preceding paper, it was reported that the specific pressure fluctuations with several cyclic modes were observed during uniaxial compression of an ultrafine powder bed. It was also reported that this phenomenon was deduced to always be associated with the formation of an unhomogeneous packing state or thin plate-like lamination layer in the bed.
In this paper, several modes of pressure fluctuations generated during uniaxial compression at a constant rate were reported for various combinations of experimental conditions such as particle size, initial height of powder bed, cross-head speed, surface roughness of the cylinder wall and the gap between the piston and the cylinder. The resulting fluctuation patterns were classified into five modes.
The pressure fluctuation was found to be cyclic in nature, and the moving distance of the piston per one cycle was measured. The thickness and its distribution of the lamination layer were observed and measured by a microscope. It was found that the lamination layer thickness is equivalent to the moving distance of the piston per one cycle of pressure fluctuation.抄録全体を表示PDF形式でダウンロード (915K) -
分離効率に及ぼす処理量の影響山本 健市, 牧野 学, 杉本 益規1992 年 29 巻 9 号 p. 669-675
発行日: 1992/09/10
公開日: 2010/04/30
ジャーナル フリーTo investigate the effect of feed rate F on shape separation efficiency η of the rotating conical disk with a spiral scraper for irregular particles, the shapes of particles separated on the disk were evaluated by an index ρ(tu) of rolling frictional characteristics of a particle closely related to its three-dimensional shape. The results obtained were as follows:
1. The separation efficiency η*m under hindered traveling conditions along the scraper (at larger F) depends on the separation characteristics of individual particles under the unhindered traveling condition (at F≈0), and on the number of particles arranged normal to the spiral scraper.
2. Optimal operating conditions could be derived from the above correlation.抄録全体を表示PDF形式でダウンロード (947K) -
御堂 勇治, 鈴木 宏, 坂本 和徳, 寺下 敬次郎1992 年 29 巻 9 号 p. 676-681
発行日: 1992/09/10
公開日: 2010/04/30
ジャーナル フリーMetal particles have thus far been investigated at high recording densities. We introduced the twin-screw compounding extruder for the purpose of good dispersion of metal particles. First, metal particles and a binder were mixed, and the mixtures were continuously kneaded by the extruder. The kneaded mixtures were diluted and dispersed to make magnetic paint. The kneading state could be estimated by measuring the mixing power during kneading, while the dispersibility was evaluated as a coated media by gloss, density, surface rough-ness, microscopic observation, SEM observation and by using a magnetic hysterisys curve.
As a result, the evaluations of the kneading state and dispersibility were in good agreement. It was clarified that the higher the binder to pigment ratio was, the higher the mixing power was, which indicates good dispersion.
In conclusion, continuous kneading by the extruder was found to be effective in producing well-dispersed metal magnetic paint.抄録全体を表示PDF形式でダウンロード (3895K) -
杉山 和夫, 高橋 秀樹, 今野 成夫, 田中 摂子, 松田 常雄, 上西 雅利, 橋詰 良樹1992 年 29 巻 9 号 p. 682-687
発行日: 1992/09/10
公開日: 2010/04/30
ジャーナル フリーThe surface states of aluminum nitride powders prepared by the direct nitriding of aluminum and the reduction-nitriding of alumina respectively, were investigated by means of X-ray photoelectron spectroscopy (XPS), temperature programmed desorption (TPD) and FT-IR spectroscopy. Four kinds of elements, aluminum, nitrogen, oxygen and carbon were observed on the surface of the samples. The surface concentration of oxygen was about 30 times larger than the bulk concentration, and the surface oxygen was involved in the formation of the thin layer of aluminum oxide and hydroxide. A new waterproof technique for aluminum nitride powders could be developed by treating them in a stream of carbon dioxide gas containing saturated steam at room temperature. The structure of the surface-stabilized samples was characterized by TPD and FT-IR measurements, and the surface thin film was composed of an ammonium aluminum carbonate hydroxide.抄録全体を表示PDF形式でダウンロード (2038K) -
超微粒子研究の立場から木村 啓作1992 年 29 巻 9 号 p. 688-694
発行日: 1992/09/10
公開日: 2010/04/30
ジャーナル フリーPDF形式でダウンロード (3327K) -
宮南 啓1992 年 29 巻 9 号 p. 695-700
発行日: 1992/09/10
公開日: 2010/04/30
ジャーナル フリーPDF形式でダウンロード (948K) -
横山 豊和1992 年 29 巻 9 号 p. 714-716
発行日: 1992/09/10
公開日: 2010/04/30
ジャーナル フリーPDF形式でダウンロード (439K)
- |<
- <
- 1
- >
- >|