巻号一覧
126 巻, 1 号
選択された号の論文の4件中1～4を表示しています
- |<
- <
- 1
- >
- >|
論文
-
Chuantong Wang, Katsunori Shida2006 年 126 巻 1 号 p. 1-6
発行日: 2006年
公開日: 2006/04/01
ジャーナル フリーIn this study, we propose a novel ball form multifunctional sensor which can measure azimuth and elevation angle at the same time, and rotating speed is also sensed. We use 4 electrodes arranged on the surface of a ball which is half filled with water. Since water will keep aclinic when the ball leans to any direction, the capacitance between electrodes will change correspondingly. Steady rotating speeds lead to different curves on the surface of water which changes the dielectric distribution of capacitances between electrodes. We use 3 capacitances to determine the space angle and rotating speed. The output functions of sensor and corresponding input value reconstructing method are furthermore proposed. Experiment and analysis results show that it is effective to sense 3 inputs by this multifunctional sensor.抄録全体を表示PDF形式でダウンロード (1326K) -
Hiromasa Yagyu, Shigehiko Hayashi, Osamu Tabata2006 年 126 巻 1 号 p. 7-13
発行日: 2006年
公開日: 2006/04/01
ジャーナル フリーAn injection molded plastic micro tip array was fabricated. First, an inversed conical hole with a sharp tip and a high aspect ratio was fabricated by irradiating a low power output Nd:YVO4-SHG laser beam for several milliseconds on Au nanoparticles dispersed ethylcellulose. Then, an epoxy micro tip array was fabricated by the cast method using the inversed conical hole as a mother structure. This was followed by nickel electroforming to make a nickel-mold mother. Finally, plastic injection compression molding was carried out to form the final plastic micro tip array. By optimizing several processing parameters, a polyethylene micro tip array with a height of about 100 μm and a diameter of about 50 μm was successfully realized.抄録全体を表示PDF形式でダウンロード (1962K) -
Tomomi Sakata, Hiromu Ishii, Yuichi Okabe, Norio Sato, Masao Nagase, T ...2006 年 126 巻 1 号 p. 14-18
発行日: 2006年
公開日: 2006/04/01
ジャーナル フリーThis paper describes the electrodeposition characteristics of an organic insulator film on a gold surface. In the electrodeposition, there are two reaction patterns depending on the solution temperature. Below around 30°C, the film thickness saturates regardless of deposition time after it rapidly increases. On the other hand, above around 30°C, the film thickness gradually increases with time and does not saturate. Using the solution temperature of 30°C, the organic dielectric was deposited to coat microelectromechanical-system structures. The deposition was confirmed to occur only on the gold electrode to which a voltage was applied. The fabricated structures with the coated electrodes were protected from the electrical shorts between the actuator and the gold electrode, even though pull-in occurred.抄録全体を表示PDF形式でダウンロード (7248K) -
水谷 好孝, 松田 裕之, 石地 徹, 古屋 長一2006 年 126 巻 1 号 p. 19-23
発行日: 2006年
公開日: 2006/04/01
ジャーナル フリーA superior electrochemical gas sensor has been developed by using a novel gas diffusion membrane consisting of carbon powder and poly-fluorocarbon for the detection of toxic gases. The gas permeability of the gas diffusion membrane depends on the poly-fluorocarbon composition in the membrane. With a decrease of the poly-fluorocarbon composition in the membrane, the electrochemical gas sensor shows high sensitivity for the detection of toxic gases, such as arsine and silane.抄録全体を表示PDF形式でダウンロード (4889K)
- |<
- <
- 1
- >
- >|