JAPAN TAPPI JOURNAL
Online ISSN : 1881-1000
Print ISSN : 0022-815X
ISSN-L : 0022-815X
Volume 18, Issue 12
Displaying 1-6 of 6 articles from this issue
  • [in Japanese], [in Japanese]
    1964Volume 18Issue 12 Pages 509-520
    Published: December 05, 1964
    Released on J-STAGE: November 10, 2009
    JOURNAL FREE ACCESS
    Download PDF (2081K)
  • [in Japanese], [in Japanese]
    1964Volume 18Issue 12 Pages 521-536
    Published: December 05, 1964
    Released on J-STAGE: November 10, 2009
    JOURNAL FREE ACCESS
    Download PDF (2550K)
  • [in Japanese]
    1964Volume 18Issue 12 Pages 537-545
    Published: December 05, 1964
    Released on J-STAGE: November 10, 2009
    JOURNAL FREE ACCESS
    Download PDF (1205K)
  • [in Japanese]
    1964Volume 18Issue 12 Pages 546-550
    Published: December 05, 1964
    Released on J-STAGE: November 10, 2009
    JOURNAL FREE ACCESS
    Download PDF (4204K)
  • Fumio Oba, Tadao Yamaji, Takashi Kadoya
    1964Volume 18Issue 12 Pages 551-558
    Published: December 05, 1964
    Released on J-STAGE: January 22, 2010
    JOURNAL FREE ACCESS
    In the Previons paper, it was shown that there was close correlation between the Canadian Standard Freeness and drainage, and that it was possible to know the Freeness by measuring the latter.
    Here according to this principle, the authors made a new Freenes-tester which has an apparatus drising a cylinder with wire cloth and an automatic recorder measuring the time required for water to reach to a given level.
    Under different kinds of conitions, the new tester was used.
    The tester was tested instock of L-BKP (cons. 0.5%) and N, L-mixed BKP (cons. 2.7%) in the range of freeness 200cc450cc and it was recognized that there was linear relationship between reading of the tester and freeness in the log-log scale, besides there were only small fluctuations in each measuring point.
    In general, the bottom wire cloth type was used in the low consistency of stock and the side wire cloth type was used in the high consistency.
    The tester, which was the side wire cloth type, was really used in measuring the freeness of L-BKP stock (csf=350cc, 420cc, consistency 4.8%) in a paper-mill and there were only about ±10cc differences between the freeness obtained by the tester and really measured values.
    Finally the influences of temperature, consistency, clay-contents and flow rate of stock to the reading of the tester were discussed.
    Download PDF (1241K)
  • [in Japanese]
    1964Volume 18Issue 12 Pages 559-565
    Published: December 05, 1964
    Released on J-STAGE: November 10, 2009
    JOURNAL FREE ACCESS
    Download PDF (6800K)
feedback
Top